How to Install

At SIA Wellbeing, we want you to get the best possible results from every product you purchase. That’s why each item comes with clear, step-by-step installation guidance designed to make setup quick, simple, and stress-free.

Hand Held Shower Heads

  1. STEP 1. PLACE RUBBER O-RING

    Unscrew the original shower head from the flexible hose. Ensure the rubber O-ring (2 supplied) is placed in the exposed end of the shower hose before step 2.

  2. STEP 2. SCREW ON SHOWER FILTER

    Screw the Sía shower filterhead onto the shower hose and turn clockwise to tighten by hand.

  3. STEP 3. LET THE WATER RUN

    Before use, let the water run through the filter for a few minutes to remove excess carbon particles. Then you are ready to feel the benefits of Sía's cleaner, clearer water.

Wall Mounted Shower Heads

  1. STEP 1. WRAP NEW TEFLON TAPE

    Unscrew the original shower head. Clean threaded pipe of shower arm with cloth. Wrap the Teflon Tape (included), tightly around the thread of the original exposed pipe - 4-6 times around the threads should be sufficient.

  2. STEP 2. PLACE RUBBER O-RING

    Ensure one of the 2 supplied rubber O-rings is placed on the inlet fitting of shower filter (one spare is included). This will increase sealing. Your Sía shower head is now ready to be installed. Please note your introductory filter is preloaded.

  3. STEP 3. SCREW ON SHOWER FILTER

    Screw the Sía shower filter on the shower arm and turn clockwise to tighten by hand. If additional tightening is needed, use a soft cloth to protect the surface and tighten with a wrench. Before use, let the water run for a few minutes to remove excess carbon particles. Then you are ready to feel the benefits of Sía's cleaner, clearer water.